Remove design steps

<< Click to Display Table of Contents >>

Navigation:  Getting started >

Remove design steps

Previous pageReturn to chapter overviewNext page

► IMPELLER/ STATOR/ VOLUTE | Additional | Remove design steps

If you make any design modifications on the current component then all following design steps are adapted automatically (parametric model).

However, if you would like to start with an automatic generated CFturbo initial design, certain design steps can be removed manually. Then CFturbo continues with new initial design data. For that purpose you have to select the appropriate design step to be removed and then press the OK-button.

Of course, all following design steps after the selected one are removed too.