Model settings

<< Click to Display Table of Contents >>

Navigation:  Impeller >

Model settings

Previous pageReturn to chapter overviewNext page

► IMPELLER | Model settings

On dialog Model settings you can specify how many data points are to be used for the 3D model and for the point based export formats.

The number of points can be set for both cases separately for all geometry parts.

Meridian:        hub/shroud

Blade:                mean line, pressure/suction side, leading/trailing edge


3D Model

Distance tolerance

The distance tolerance defines the maximum allowed distance between sewed surfaces, e.g the faces of a solid.

If it is too small, the solids cannot be created.

If it is too big, small faces are ignored when creating a solid.

Point Export


Select from 3 global presets.

When a new impeller is created the model settings of the last opened impeller are carried over.