Component

<< Click to Display Table of Contents >>

Navigation:  Menu >

Component

Previous pageReturn to chapter overviewNext page

These context sensitive menu is used for designing the currently selected component.

A separate tab with the corresponding design steps is available for each component type:

IMPELLER

(Mean line
design mode)

 

 

 

(Airfoil/ Hydrofoil design mode)

STATOR

VOLUTE

Menu items and buttons only become active in accordance to the current design state. Each finished design steps can be opened again whereas all depending design steps and components are updated automatically. Manual removing of complete component's design steps is possible in order to continue with CFturbo® initial design (see Remove design steps).

For designing the complete geometry of a single component you have to run through all items of the appropriate menu step by step.

Alternatively all these menu items can be selected in the Meridian view using the toolbar directly on the selected component (see Meridian).